Filter
Top Products
5) MESSAGE RTN : Message display ON/OFF
ON : A message indicating the result of AWB/ABB execution in the DIRECT mode
is displayed.
OFF : A message indicating the result of AWB/ABB execution in the DIRECT mode
is not displayed.
6) REMOTE : Set remote control baud rate
Use R and L to set for 2400, 4800, 9600 or 19200 bps. Set to 9600 bps when using
the optional RC-Z3 remote control box.
7) REMOTE TYPE : Selects between modes 1 and 2.
MODE 1: Select to use the same computer commands as other camera models
(e.g., HV-C20 series).
MODE 2: Normal setting. Use for the RC-Z3 remote control box.
8) ID/TITLE : Change to ID/TITLE menu
9) Pixel correct : White flaw compensation on/off
Normally set to on. When image processing equipment is used, since the data of 1
pixel are not precise, the off setting might provide better results in such cases.
17. ID/TITLE
ID and title display position and data setting menu.
1) ID : ID display position setting
Once an ID is assigned, it becomes possible to control a particular camera unit
remotely from a personal computer according to its ID. That is, multiple camera
units can be remote-controlled individually from one persona computer.
At this function item, specify whether the ID is displayed on screen or not. In case
that the ID is displayed on screen, specify its display position also.
OFF : Not displayed.
TOP TITLE
BOTTOM TITLE
TOP ID
BOTTOM ID
ID/TITLE Display Position
TOP : Displayed at the upper right corner
of screen.
BOTTOM : Displayed at the lower right
corner of screen.
2) At this function item, specify whether the
TITLE is displayed on screen or not. In case
that the TITLE is displayed on screen, specify
its display position also.
OFF : Not displayed.
TOP : Displayed at the upper left corner of screen.
31