Filter
Top Products
VIEWING THE PICTURE PLAYED BACK ON YOUR TV
65
1. Connect the AV stereo output cord (provided) to "AUDIO IN" and "VIDEO IN" of your
TV.
NOTES:
• If your TV has a single (mono) audio input, connect either the left or right audio plug to the
audio input on the TV.
• If your TV has an "S-VIDEO IN" jack, connect the "S-VIDEO" plug (black) to the TV
instead of the "VIDEO IN" plug (yellow).
2. Connect the other end of the AV stereo output cord to "AV IN/OUT" of your
camera/recorder.
3. Turn on TV.
4. Perform same procedures in steps 4 through 7 of "Example 1" above.
Example 3: If your TV is a regular TV,
Camera hookup to regular TV Illustration
1. Disconnect the VHF antenna leads from the rear of the TV receiver.
NOTE: Leave the UHF antenna leads connected to the TV.
2. Connect the VHF antenna lead to "IN FROM ANT" on the RF output adapter. If the
cable is round (75-ohm), it will connect direcly to the "IN FROM ANT". If it is the flat type
(300-ohm), connect it to the antenna adapter (300-ohm to 75-ohm) and slip the adapter
on to the "IN FROM ANT" terminal.
3. Connect the 75-ohm coaxial cable to "OUT TO TV" on the RF output adapter.
4. Connect the other end of the VHF antenna terminal on the TV, as illustrated.
5. Connect the connector cable from RF output adapter to "AV IN/OUT" jack on the
camera/recorder.
6. Turn on the TV and set to channel 3 unless channel 3 is one of the TV stations in
your area. If channel 3 is used in your area, set your TV to channel 4.
7. Set the RF channel select switch on the RF output adapter to "CH3" or "CH4" to
match the channel selector on your TV.
8. Perform same procedures in steps 4 through 7 of "Example 1".