Honeywell HD3MDIP Security Camera User Manual


 
HD3MDIP/X Network Camera Reference Guide
Document 800-04132V1 Rev A 61
01/10
2. In the Scene Change Threshold list, select one of the following options:
3. Click Apply.
Note To turn off camera field of view change detection, select Disable in the Scene
Change Threshold list. Disable is the default value.
Note You must click Apply after you make changes to any settings to save those
changes. Settings are not saved unless you click Apply.
Configuring Video Motion Detection
For motion detection, an Administrator can enable and configure up to 5 zones within a
scene. The enabled and configured zones will be monitored for motion.
1. Click the Region drop-down menu, then select a region from the five available.
2. Click the VMD drop-down arrow, and select Enable.
The Regions appear in their default positions.
3. Click Apply.
4. Click and drag the box to resize and place it over the camera image.
5. Select the sensitivity level (High, Medium, Low).
Table 4-8 Scene Change Threshold Values
Value To detect …
High (80%) Maximum change in the camera field of view. The alarm
message appears when tampering causes at least an 80%
change in the HD3MDIP/X camera field of view.
Medium (50%) Medium change in the camera field of view. The alarm
message appears when tampering causes at least a 50%
change in the HD3MDIP/X camera field of view.
Low (30%) Minimum change in the camera field of view. The alarm
message appears when tampering causes at least a 30%
change in the HD3MDIP/X camera field of view.