Filter
Top Products
40
When you turn the camera on and press the
shutter release button halfway down, the
channel of the flash unit is registered on the
camera.
(Preparation of Separated Flash Unit)
Next, set the channel of the separated (wireless)
flash unit to the same channel as the flash unit
attached to the camera.
Place the other AF360FGZ in the desired
position.
Set the power switch of the flash unit to
(WIRELESS).
Set the wireless mode switch to (S), so that
SLAVE is displayed in the upper right corner of
the LCD panel.
Slide down the setting switch to the (yellow
dot) to display the channel on the LCD panel.
Press the channel button (CH) and select the
same channel that the flash unit attached to
the camera has been set to.
Slide the setting switch back up to the (white
dot).
● The two flash units must be set to the same
channel, otherwise the separated flash unit will
not discharge.
(Photographing)
Confirm that both flash units are fully charged,
and take the photograph.
A lamp on the wireless flash unit will blink.
2
3