Filter
Top Products
49
■Slave Mode Setting
To properly control the slave flash, it is necessary to set
the slave mode settings.
Procedure
Slide the setting switch up.
Press the LCD panel illumination button (LIGHT)
for 2 seconds or more. SLAVE1 will be displayed.
Pressing the select button (S) switches between
1 and 2.
● The flash will not discharge properly if the slave
mode was set to the wrong mode. It may not
discharge at all or may discharge simultaneously
with the control flash.
Press the LCD panel illumination button (LIGHT)
to finish setting.
●
In SLAVE2, fluorescent lamps flicker may contribute
to flash unit’s erroneous firing on rare occasions.
2 seconds
or more
1: When photographing in wireless mode
2: When photographing with slave flash
1
2
3
4