Filter
Top Products
22
NETWORK SETTING
Network IP Camera Name The default camera name is “IPCamera_MJPEG”. It is recommended to change to
a meaningful name for the Camera.
IP Address Enter an unused IP Address within the IP address range used on your LAN. If the IP
Address of your LAN is from the 192.168.2.1 to 192.168.2.254, you can set an
unused IP Address from the range for the Camera, for example: 192.168.2.250.
Subnet Mask The Subnet Mask field must match the subnet setting on your LAN.
For example: 255.255.255.0.
Gateway The Gateway is used to forward frames to destinations in a different subnet on the
Internet. The Gateway setting must be the same as the gateway used by the PCs on
your LAN.
DNS Server DNS Server (Domain Name Server) that translates names to IP addresses. Set to
the same DNS Server as the PCs on your LAN.
Video Port The Video Port is used to transmit or receive the video stream through the network.
The default port setting is “4321”. If you want to view the video from the Camera,
this port setting should be correct.
Web Port This camera supports web connection and the default web port is 80. Since the
web server may use port 80, you can use a different port for the Camera. If you
change the web port from 80 to 8080, you must type http://192.168.2.3:8080
to connect to the Camera through a web browser.
USING THE ADMINISTRATOR UTILITY