Filter
Top Products
CV-L105
9. Specifications
9.1. Specifications table
Specifications CV-L105
Scanning system
Line scan
Pixel clock
15 or 30 MHz, user selectable
Line rate (scan rate)
Up to 7172 lines/sec at 15 MHz, and up to 14285 lines/sec at 30 MHz
CCD sensor
3 x 2048 line scan sensors mounted on an RGB prism
Sensing area
28.7 mm x 14 µm
Effective pixels
3 x 2144
Pixels in video output
3 x 2048
Cell size
14 µm x 14 µm
Prism block
Dichroic beam splitter. Centre wavel. Red 630 nm, Green 535 nm, Blue 450 nm
CCD alignment precision
Typ. 0,5 pixel, Max 1 pixel
Sensitivity on sensor
Radiometric at 3100K
6.7 mV/nj/cm
2
. (7.2 LSB/nj/cm
2
at 8 bit)
Sensitivity on sensor
Photometric at 3100K
400 Lux. (Exposure time 1 msec. Max. gain, 100% video on green)
S/N ratio
15 MHz. R: 53 dB, G: 56 dB, B: 50 dB
30 MHz. R: 47 dB, G: 50 dB, B: 44 dB
Video output
3 x 8 bit EIA-644 Low Voltage Differential Signalling LVDS.
Based on NS DS90C032.
Gain range
12 dB
Trigger input
EIA-644 LVDS. Based on NS DS90C031
STROBE output
(for latching video into frame grabber) EIA-644 LVDS
LEN output
(valid video duration) EIA-644 LVDS
Trigger modes
Continuous, Pulse Width Control, Edge Pre-select
Functions controlled by input
signal on interface connector
Pixel rate and binning
RS-232C control enable/disable
Functions input
TTL levels. Internal 4.7 kΩ pull-up
Functions controlled by RS-
232C
Pixel clock select, Binning, Trigger mode, Scan rate, Shutter speed, individual RGB gain,
individual RGB offset.
Communication baud rate
9600
Diagnostics
LED for power, LED for trigger
Operating temperature
-5ºC to +45ºC
Humidity
20 - 80% non-condensing
Storage temp./humidity
-25ºC to +60ºC/20 - 80% non-condensing
Lens mount
Nikon F-mount
Power
12V DC ± 5% 12W (1A)
Dimensions
90 x 90 x 123 mm (HxWxD)
Weight
1100 g
9.2. Spectral Sensitivity
Wave length (nm)
400 500 600 700 800
1.0
0.8
0.6
0.4
0.2
0.0
Relative transmission
IR stop
B G R
Fig. 23. Spectral sensitivity.
- 20 -