Filter
Top Products
Page 10
TM-2016-8 and TM-2016-8CL Progressive Scan Shutter Camera
Installation
2.2.3 Shutter Speed Control Dial (TM-2016-8 only)
2.2.4 RS-232 Communication Cable (TM-2016-8 only)
FIGURE 4. Serial Communication Cable RS-232B-12
The RS-232 controller set CS-232E includes the RS-232B-12 interface cable, the software disk, and a
quick-start card. The TM-2016-8 camera’s built-in look-up table (LUT) can be controlled by an external
RS-232 interface. The camera settings can be programmed or changed using the communication cable
and software. Commands from the RS-232 interface will over-write the rear panel switch settings of the
camera. Please refer to the AccuPiXEL Series Camera Control Software manual for details on the
graphical user interface.
Shutter speed can be selected by switching the shutter dial to the appropriate
setting (0 through 9). The factory default settings correspond to the shutter
speeds as shown in Table 5 below.
TABLE 5. Shutter Speed Control Dial
Manual Async
0 no shutter no shutter
11/30 1/8,000
21/60 1/4,000
3 1/125 1/2,000
4 1/250 1/1,000
5 1/500 1/500
6 1/1,000 1/250
7 1/2,000 1/125
8 1/4,000 1/60
9 1/8,000 Ext. pulse-width control
0
1
2
3
4
6
7
8
9
5
Receptacle
40±3mm
75mm±5mm
Jack
1925±10mm
2000±20mm
190±5mm
6
1
59