Filter
Top Products
Getting Started 13
EN Camera
Series
2 Getting Started
2.1 Required Equipment
Figure 1. Typical Equipment Setup
*Each camera requires a PD-12 12-V power supply.
For details, please see "Power Supplies and Cable Setup."
• PD-12 power supply
• Cat5e/6 Ethernet cable
• 10/100/1000 Ethernet switch
• Debug-232 serial/power cable (JAI Inc. part number 31013219)
2.2 Network Settings
2.2.1 Default Network Settings for the EN Camera
The factory default network setting for the EN camera is as follows::
IP address : 10.0.0.65
Subnet mask : 255.255.255.0
Default gateway : 255.255.255.255 (disabled)
You must set up your computer network properly in order to allow it to communicate with the
camera. It is very important that your PC NOT be assigned the same IP address as the camera. If you
need to change the IP address, follow the instructions in Section 2.2.2 on page 4.
2.2.2 Changing the IP Address of the EN Camera
If you need to change the IP address of your EN Camera, you can do so using either the EN setup
software or the debug RS-232 serial/power cable. Choose the method that is most appropriate for
your application, and follow the steps listed.