Filter
Top Products
Interpretation Change the motion detect sensitivity. Specify a value between 0 to 100. The larger the value, the
higher will be the sensitivity. The change is saved by the API, camera.status=save. If the change is not saved, the
setting is restored by reboot.
Allowed users admin, operator
Getting Motion Detect Mask
Format /api/param?camera.detection.area
Example of response camera.detection.area=00010203040506070809,,,&200 OK
Interpretation Acquire the mask of motion detect. 20 ASCII characters will be returned.
The screen is made up of 15x 9 = 135 blocks, and mask can be set to on/off for each block. This information can
be represented in 135 bits = 17-byte hexadecimal. (Response is returned in ASCII character strings. Therefore,
34 characters will be returned.) The bit string will appear as follows when mask is set to off for the top left block
only.
10000000 00000000 00000000 ,,,
Storage in bytes will begin from the LSB and represented in a hexadecimal value as shown below.
01 00 00 00 00 00 00 00 00 00,,,
The hexadecimal value denotes the 34 ASCII characters acquired via this API that are expressed in ASCII codes.
For example, the following character string will be returned when only the top left and bottom right blocks are
masked.
camera.detection.area=0100000000000000,,,0080
Allowed users admin, operator, user
Setting Motion Detect Mask
Format /api/param?camera.detection.area=data
Example /api/param?camera.detection.area=00010203040506070809,,,
Example of response camera.detection.area&202 Accepted(camera.status=save)
Interpretation Change the motion detect mask. Specify using a 34 ASCII character string. Refer to the item on
"Getting Motion Mask" on the interpretation of this character string. To mask all blocks, specify all zeros in the
ASCII character string. The change is saved by the API, camera.status=save. If the change is not saved, the
setting is restored by reboot.
Allowed users admin, operator
18. JVC API for Tampering Detect
The APIs below are related to the Tampering detection. These are equivalent to the features on the Tampering
Detection page of the WEB setting page. Refer to the instruction manual for details on the Tampering Detection