Filter
Top Products
Setting Tampering Detect Sensitivity
Format /api/param?camera.detection(tampering).temporal=data
Example of response camera.detection(tampering).temporal&202 Accepted(camera.status=save)
Interpretation Change the tampering detect time. Specify a value between 0 to 120. The change is saved by the
API, camera.status=save. If the change is not saved, the setting is restored by reboot.
Allowed users admin, operator
19. JVC API for Network Basics
The APIs below are related to the basics of networks. These are equivalent to the features on the Basic page of
the WEB setting page. Refer to the instruction manual for details on the Basic page.
Enabling Network Setting Changes
Format /api/param?network.interface.status=restart
Example of Response network.interface.status&200 OK
Interpretation Changes of following network parameters become valid by this API.
DHCP, IP Address, Subnet Mask, TTL, MTU, TOS, Negotiation, IPv6
Changes are not reflected in the actions until this API is used. APIs to get settings of those parameters return
previous values until this API is used. When this API is issued, the camera reboots in about 1 minute.
Allowed user admin
Getting DHCP Setting
Format /api/param?network.interface.dhcp.status
Example of Response network.interface.dhcp.status=off&200 OK
Interpretation Acquire the current DHCP setting.
Allowed users admin, operator, user
Setting DHCP
Format /api/param?network.interface.dhcp.status=data
Example /api/param?network.interface.dhcp.status=on
Example of Response
network.interface.dhcp.status&202 Accepted(network.interface.status=restart)
Interpretation Change the DHCP setting. Specify "on" or "off". To validate the change, use
"network.interface.status=restart" API that reboots the camera in about 1 minute.
Allowed user admin