Filter
Top Products
EN
26
FOR RECORDING
Manual Focus
To obtain correct focus.
1 If you are using the viewfinder, you should already
have made the necessary viewfinder adjustments
(
੬ pg. 8).
2 Set the Power Switch y to “ ” while pressing
down the Lock Button t located on the switch, then
press FOCUS * (੬ pgs. 46 and 47). The manual
focus indicator appears.
3 To focus on a farther subject, rotate the MENU/
VOLUME wheel % towards “+”. “ ” o appears and
blinks.
To focus on a nearer subject, rotate the MENU/
VOLUME wheel % towards “–”. “ ” o appears and
blinks.
4 Press the MENU/VOLUME wheel % in. Focus
adjustment is complete.
To reset to Auto Focus, press FOCUS * twice or set
the Power Switch y to “ ”.
If FOCUS * is pressed once, the camcorder will enter
the focus adjustment mode again.
NOTES:
● Be sure to focus the lens in the maximum telephoto
position when you use the Manual Focus mode. If you
focus in on a subject in the wide-angle position, sharply
focused images cannot be obtained when zoomed up
because the depth-of-field is reduced at longer focal
lengths.
● When the focus level cannot be adjusted any further or
closer, “
” or “ ” will blink.
Exposure Control
Manual exposure adjustment is recommended in the
following situations:
• When shooting using reverse lighting or when the
background is too bright.
• When shooting on a reflective natural background
such as at the beach or when skiing.
• When the background is overly dark or the subject
light.
1 Set the Power Switch y to “ ” while pressing
down the Lock Button t located on the switch. Open
the LCD monitor fully or pull out the viewfinder fully.
2 Press the MENU/VOLUME wheel % in. The Menu
Screen appears.
3 Rotate the MENU/VOLUME wheel % to select
“ (EXPOSURE)”, then press it.
4 Rotate the MENU/VOLUME wheel % to select
“MANUAL”, then press it. The Menu Screen disappears.
The exposure control indicator appears.
5 Rotate the MENU/VOLUME wheel % towards “+” to
brighten the image, or towards “–” to darken the image.
(maximum ±6)
6 Press the MENU/VOLUME wheel % in. Exposure
adjustment is complete.
To Return To Automatic Exposure Control . . .
..... select “AUTO” in step 4. Or, set the Power Switch
y to “ ”.
To Brighten The Subject Quickly . . .
..... press BACKLIGHT !. ) is displayed and the
subject is brightened. If pressed again, )
disappears and the brightness returns to the
previous level.
• +3 exposure has the same effect as the BACKLIGHT
! Button.
• Using BACKLIGHT ! may cause the light around the
subject to become too bright and the subject to
become white.
• Backlight compensations is also available when the
Power Switch y is set to “ ”.
NOTE:
You cannot use the manual exposure control at the same
time with backlight, spotlight (
੬ pg. 23) compensation and
“SNOW” (
੬ pg. 23).
While focusing on
a nearer subject
While focusing on
a further subject
Focus detection zone
1 GR-D90/70/30US EN 23-34 02.11.6, 3:12 PM26