Filter
Top Products
20 EN
RECORDING
Advanced Features (cont.)
System Menu Explanations
Date/Time Menu Explanations
ON Makes all the indications appear in the camcorder (੬ pg. 21).
OFF Keeps all the indications (except the tape running indicator, warnings,
etc.) from appearing in the camcorder (੬ pg. 21).
OFF Keeps the camcorder’s display from appearing on the connected TV
screen.
ON Makes the camcorder’s display appear on screen when the camcorder is
connected to a TV.
ON Makes the date/time settings appear in the camcorder (੬ pg. 21).
OFF Keeps the date/time settings from appearing in the camcorder.
Allows you to set the current date and time (੬ pg. 8).
INDICATION
ON SCREEN
*
DISPLAY
DATE/TIME
: Factory preset
Usually the distance to a subject where the lens is in focus depends on
the zoom magnification. Unless there is a distance more than 1m to the
subject, the lens is out of focus at the maximum telephoto setting. When
set to “ON”, you can shoot a subject as large as possible at a distance of
approx. 60 cm.
•Depending on the zoom position, the lens may go out of focus.
Disengages the function which cuts down on noise created by wind.
Helps cut down on noise created by wind.
•“ ” appears.
•The quality of the sound will change. This is normal.
Enables recording of stereo sound on four separate channels, and is
recommended for use when performing audio dubbing.
Enables recording of stereo sound on two separate channels.
This number is necessary when connecting the camcorder to a device such as a
computer using the J terminal (JLIP). The numbers range from 01 to 99. Factory setting
is 06.
Automatic demonstration will not take place.
Demonstrates certain functions such as Programme AE with special
effects, etc., and can be used to confirm how these functions operate.
When “DEMO. MODE” is set to “ON” and the Recording Menu is
closed, demonstration starts.
NOTES:
●
If a tape is in the camcorder, the demonstration cannot be turned on.
●
By turning off the camcorder, “DEMO. MODE” is set to “OFF”
automatically.
OFF
ON
OFF
ON
32 kHz
48 kHz
OFF
ON
TELE MACRO
WIND CUT
SOUND MODE
ID NUMBER
DEMO. MODE
* You can also change “ON SCREEN” to “ON” or “OFF” by pressing the DISPLAY button on the RM-V711U
remote control.