Filter
Top Products
EN53
SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION
32.
The LCD monitor
indications are distorted.
33.
Images on the LCD
monitor are jittery.
34.
The LCD monitor, the
viewfinder and the lens
have become dirty (ex.
fingerprints).
35.
An unusual mark appears.
36.
An error indication
(E01 — E06) appears.
37.
The charger indicator on
the AC Power Adapter/
Charger does not light.
38.
The recording mode
indicator “LP” blinks.
39.
Picture does not appear on
the LCD monitor.
40.
When the image is printed
from the printer, a black
bar appears at the bottom
of the screen.
41.
When the camcorder is
connected via the DV
connector, the camcorder
does not operate.
32.
•During playback of an
unrecorded portion, High-
speed Search and still
playback, LCD monitor
indications appear distorted.
This is not a defect.
33.
•The speaker volume is too
great.
34.
————
35.
————
36.
•A malfunction of some kind
has occurred. In this case
the camcorder’s functions
become unusable.
37.
•The temperature of the
battery is extremely high/low.
•Charging is difficult in
places subject to extremely
high/low temperatures.
38.
•This occurs when recording
in the LP mode is not
available. After the indicator
blinks, the recording mode
switches to “SP” and
recording goes on.
39.
•The lens cap is attached.
•␣ The LCD monitor is not
open at an angle of over 45
degrees.
• The LCD monitor’s
brightness setting is too
dark.
40.
•This is not a malfunction.
41.
•The DV cable was plugged/
unplugged with power
turned on.
32.
————
33.
•Turn the speaker volume
down (੬ pg. 29).
34.
•Wipe them gently with a
soft cloth. Wiping strongly
can cause damage.
35.
•Check the section of the
manual that explains LCD
monitor/viewfinder
indications (੬ pg. 60, 61).
36.
•Remove the power supply
(battery pack, etc.) and wait a
few minutes for the indication
to clear. When it does, you
can resume using the
camcorder. If the indication
remains even though you
repeat the above two or three
times, please consult your
nearest JVC dealer.
37.
•To protect the battery, it is
recommended to charge it
in places with a temperature
of 10°C to 35°C (50°F to
95°F) (੬ pg. 55).
38.
————
39.
•Remove the lens cap
(੬ pg. 12).
•␣ Open the LCD monitor to
an angle of over 45 degrees.
•␣ Adjust the brightness of the
LCD monitor (੬ pg. 12).
•␣ If the monitor is tilted
upward to 180 degrees,
open it fully (੬ pg. 12).
40.
•By recording with “DIS”
activated (੬ pg. 19) this
can be avoided.
41.
•Turn the camcorder’s power
off and on again, then
operate it.