Filter
Top Products
EN61
Warning Indications
Indications Function
Displays the battery remaining power.
Remaining power level: high
Remaining power level: exhausted
As the battery power comes close to nil, the battery indicator blinks.
When the battery power is exhausted, power turns off automatically.
Appears when no tape is loaded, or when the erase protection tab is set to
“SAVE”. (੬ pg. 9)
Appears if dirt is detected on the heads during recording. (੬ pg. 56)
Appears if condensation occurs. When this indication is displayed, the camcorder turns
off automatically.
Appears for 10 seconds after power is turned on if there is no tape loaded.
Appears for 5 seconds after power is turned on if the lens cap is attached.
Appears when the tape ends during recording or playback. (੬ pg. 13)
Appears when Audio Dubbing is unavailable. (੬ pg. 48)
The error indications (E01 — E06) show what type of malfunction has occured. When
an error indication appears, the camcorder turns off automatically. Remove the power
supply (battery, etc.) and wait a few minutes for the indication to clear. When it does,
you can resume using the camcorder. If the indication remains, consult your nearest
JVC dealer. (੬ pg. 53)
LCD Monitor/Viewfinder Indications During Playback
No. Function
1 Displays the sound mode. (੬ pg. 31)
2 Displays the tape speed.
3 Appears while a tape is running.
4
: Playback
3
: Fast-Forward/Shuttle search
2
: Rewind/Shuttle search
6 : Pause
6
4
: Forward slow-motion
1
6 : Reverse slow-motion
e : Audio Dubbing
6e : Audio Dubbing Pause
4 Displays the date/time. (੬ pg. 31)
5 BRIGHT: Displays the brightness
of the LCD monitor. (੬ pg. 12)
VOLUME:Displays the speaker volume.
(੬ pg. 29)
6 Displays the time code. (੬ pg. 31)
6e
WIDE
PS
HIGH SPEED
25 . 12 . 99
16 : 40
TC
VOLUME
– – – – –
6
– – – – –
SOUND1
32kHz
LP
4
01 : 28 : 15
2 3
56 4
1
TAPE!
TAPE END
E01 — E06
ERROR!
REFER MANUAL
LENS COVER