JVC GR-DVL30 Camcorder User Manual


 
EN33
PLAYBACK
1
Make sure all units are turned off.
2
Connect the camcorder to a TV or VCR as
shown in the illustration ( pg. 32).
If using a VCR . . . go to step 3.
If not . . . go to step 4.
3
Connect the VCR output to the TV input,
referring to your VCR’s instruction manual.
4
Turn on the camcorder, the VCR and the TV.
5
Set the VCR to its AUX input mode, and set the
TV to its VIDEO mode.
To choose whether or not the following displays
appear on the connected TV . . .
•Date/Time
.... set “DISPLAY” to “ON” or “OFF” in the
Playback Menu (
pg. 30).
•Time Code
.... set “TIME CODE” to “ON” or “OFF” in the
Playback Menu (
pg. 30).
•Playback Sound Mode Display
.... set the Power Switch to “ ”. Press MENU/
BRIGHT and set “ON SCREEN” in the Date/
Time Menu (
pg. 18 – 20) to “ON” or
“OFF”. Then, set the Power Switch back to
”.
NOTES:
It is recommended to use the AC Power Adapter/
Charger as the power supply instead of the battery
pack (
pg. 7).
To monitor the picture and sound from the
camcorder without inserting a tape, set the
camcorder’s Power Switch to “ ” or “ ”, then
set your TV to the appropriate input mode.
Make sure you adjust the TV sound volume to its
minimum level to avoid a sudden burst of sound
when the camcorder is turned on.
If you have a TV or speakers that are not specially
shielded, do not place the speakers adjacent to the
TV as interference will occur in the camcorder
playback picture.
Set the video out select switch of the cable adapter
as required:
Y/C : When connecting to a TV or VCR which
accepts Y/C signals and uses an S-Video
cable.
CVBS : When connecting to a TV or VCR which
does not accept Y/C signals and uses an
audio/video cable.