Filter
Top Products
EN37
TW
Digital Dubbing
It is also possible to copy recorded scenes from the
camcorder onto another video unit equipped with a DV
connector. Since a digital signal is sent, there is little if any
image or sound deterioration.
1
Make sure the camcorder’s power is off.
2
Connect the camcorder to your video unit equipped
with a DV connector using a DV cable as shown in
the illustration.
3
Press
4
to play back the source tape.
4
While watching the playback on the monitor, engage
the DV connector-equipped video unit’s record mode
from the spot on the source tape you want to begin
recording.
NOTES:
●
It is recommended to use the AC Power Adapter/ Charger
as the power supply instead of the battery pack (
੬
pg. 7).
●
When using the camcorder for dubbing, be sure to use it
as a player. The camcorder's DV connector is only for
output.
●
If a blank portion or disturbed image is played back on
the player during dubbing, the dubbing may stop so that
an unusual image is not dubbed.
●
Even though the DV cable is connected correctly,
sometimes the image may not appear in step 3. If this
occurs, turn off the power and make connections again.
●
If “Playback Zoom” (
੬
pg. 40), “Playback Special
Effects” (
੬
pg. 41) or “Snapshot” is attempted during
playback, only the original playback image recorded on
the tape is output from the DV OUT connector.
●
Be sure to use a DV cable with core filters.
DV cable (optional)
Video unit equipped
with DV connector
To DV IN
To DV OUT
PLAY (
4
)
STOP (5)
RM-V711U
(provided)
Power Switch
Core filter
Core filter
The connectors are
located beneath
the cover.