Filter
Top Products
15
120MIN 119MIN
3MIN
2MIN (Blinking)
1MIN (Blinking)
0MIN (Blinking)
* MIN.....(Now calculating)
RECORDING
Basic Recording
NOTE:
You should already have performed the procedures listed
below. If not, do so before continuing.
●
Power (
੬
pg. 8)
●
Tape Length/Recording Mode Setting (
੬
pg. 11)
●
Grip Adjustment (
੬
pg. 13)
LOAD A CASSETTE
1
First press PUSH/OPEN and open the LCD monitor
to an angle of over 60 degrees.
Press EJECT to open the cassette holder, then insert
the cassette with the label facing out. Press PUSH to
ensure the holder is closed and locked.
Shooting while watching the LCD monitor
ENTER RECORD–STANDBY MODE
2
Make sure the LCD monitor is fully open. Slide the
LENS COVER open/close switch to open the lens
cover, then set the power switch to CAMERA.
•The power indicator lights and the camcorder
enters the Record–Standby mode.
•The scene you’re aimed at appears in the LCD
monitor, with the word “PAUSE” superimposed
upon it.
START SHOOTING
3
Tilt the LCD monitor upward/downward for best
viewability (੬ pg. 17) and press the Recording
Start/Stop button.
•The tally lamp lights while recording is in progress,
and “
REC
” appears in the LCD monitor.
STOP RECORDING
4
Press the Recording Start/Stop button again to stop
recording.
•The camcorder re-enters the Record-Standby
mode.
NOTES:
●
When you use the LCD monitor outdoors in direct
sunlight, the LCD monitor may be difficult to see. If this
happens, we recommend that you use the viewfinder
(
੬
pg. 16).
●
For other notes, refer to pg. 16.
LENS COVER
Switch
POWER
Start/Stop
Tape remaining time
indicator
LCD monitor
PUSH/OPEN
Power indicator
Tally lamp