Filter
Top Products
ADDITIONAL FEATURES FOR D.S.C.
DIGITAL STILL CAMERA (D.S.C.) RECORDING & PLAYBACK
EN 21
MasterPage: DSC_Right
To remove protection from all files stored in the
memory card
6 Rotate the MMENU/VOL. Wheel to select
“CANC.ALL”, and press it. The PROTECT screen
appears.
7 Rotate the MMENU/VOL. Wheel to select
“EXECUTE”, and press it.
● To cancel selection, select “RETURN”.
Previously stored files can be deleted either one at a time
or all at once.
1 Load a memory card. (੬ pg. 10)
2 Set the VIDEO/MEMORY Switch to “MEMORY”.
3 Set the Power Switch to “PLAY” while pressing down
the Lock Button located on the switch.
● A stored file is displayed.
4 Press the MMENU/VOL. Wheel in. The Menu Screen
appears.
5 Rotate the MMENU/VOL. Wheel to select “DELETE”,
and press it. The Sub Menu appears.
To delete the currently displayed file
6 Rotate the MMENU/VOL.
Wheel to select “CURRENT”, and
press it. The DELETE screen
appears.
7 Press 3 or 5 to select the
desired file.
8 Rotate the MMENU/VOL.
Wheel to select “EXECUTE”, and
press it.
● To cancel deletion, select
“RETURN”.
● Repeat steps 7 and 8 for all files
you want to delete.
NOTE:
If the “” mark appears, the selected file is protected and
cannot be deleted.
To delete all files stored in the memory card
6 Rotate the MMENU/VOL. Wheel to select “ALL”, and
press it. The DELETE screen appears.
7 Rotate the MMENU/VOL. Wheel to select
“EXECUTE”, and press it.
● To cancel deletion, select “RETURN”.
NOTES:
● Protected files (੬ pg. 20) cannot be deleted. To delete
them, remove protection first.
● Once files are deleted, they cannot be restored. Check files
before deleting.
CAUTION:
Do not remove the memory card or perform any other
operation (such as turning off the camcorder) during deletion.
Also, be sure to use the provided AC Adapter, as the memory
card may be corrupted if the battery becomes exhausted
during deletion. If the memory card becomes corrupted,
initialise it. (੬ pg. 23)
Still images can be dubbed from a tape to a memory
card.
1 Load a cassette. (੬ pg. 10)
2 Load a memory card. (੬ pg. 10)
3 Set the VIDEO/MEMORY Switch to “VIDEO”.
4 Set the Power Switch to “PLAY” while pressing down
the Lock Button located on the switch.
5 Set “ COPY” to “ON”. (੬ pg. 24, 28)
6 Press 4/9 to start playback.
7 At the point you want to dub, press 4/9 again to
engage Still Playback.
8 To dub the image, press SNAPSHOT.
● The “” indication appears during dubbing.
● The selected image is stored in the memory card.
NOTES:
● If SNAPSHOT is pressed in step 8 when a memory card is
not loaded, the message “COPYING FAILED” is displayed.
● If an image recorded on the tape using “WIDE MODE”
(੬ pg. 26) is dubbed to a memory card, the WIDE mode
identifying signal is not dubbed with it.
● To use Playback Special effects with a video image you
wish to dub, perform up to step 8 using the remote control
(provided). (੬ pg. 16)
● Images are dubbed in 640 x 480 pixels.
Deleting Files
DELETE
M
E
NU
RENT
ALL
RETURN
CUR
ELETED
EXECUTE
DELETE?
RETURN
Dubbing Still Images Recorded On A Tape
To A Memory Card
GR-D63EK.book Page 21 Tuesday, December 16, 2003 7:44 PM