Filter
Top Products
TROUBLESHOOTING
44 EN
MasterPage: Left
Appears when the memory card’s memory is full and
shooting is not possible.
●Appears if dubbing of copyguarded signals is attempted
while this camcorder is being used as a recorder.
●Appears in the following cases when dubbing from a
tape to a memory card (as digital stills):
• when no memory card is loaded.
• when the memory card’s memory is full.
• when the memory card is not formatted.
• when a write-protected SD Memory Card is loaded.
(੬ pg. 21)
Appears if there is no memory card loaded when you
attempt to record on a memory card or access data on a
memory card.
Appears when there is a problem with a memory card
and its memory is corrupt, or it has not been initialised.
Initialise the memory card. (੬ pg. 23)
Appears if there are no image files stored in the memory
card when you attempt memory card playback.
Appears when the camcorder does not recognise the
loaded memory card. Remove the memory card once
and insert it again. Repeat these procedures until no
indication appears. If the indication still appears, the
memory card is corrupted.
Appears when playing back a file that is not compatible
with DCF or a file with a size that is not compatible with
this camcorder.
Appears when you attempt to shoot digital still images
when the write protection tab on the SD Memory Card is
set to the “LOCK” position.
The error indications (E01, E02 or E06) show what type
of malfunction has occurred. When an error indication
appears, the camcorder turns off automatically. Remove
the power supply (battery, etc.) and wait a few minutes for
the indication to clear. When it does, you can resume
using the camcorder. If the indication remains, consult
your nearest JVC dealer.
The error indications (E03 or E04) show what type of
malfunction has occurred. When an error indication
appears, the camcorder turns off automatically. Eject the
cassette once and re-insert it, then check if the indication
clears. When it does, you can resume using the
camcorder. If the indication remains, consult your nearest
JVC dealer.
MEMORY IS FULL
COPYING FAILED
MEMORY CARD!
PLEASE FORMAT
NO IMAGES STORED
CARD ERROR!
UNSUPPORTED FILE!
CHECK CARD’S WRITE PROTECTION SWITCH
E01, E02 or E06
UNIT IN SAFEGUARD MODE REMOVE AND
REATTACH BATTERY
E03 or E04
UNIT IN SAFEGUARD MODE EJECT AND REINSERT
TAPE
GR-D63EK.book Page 44 Tuesday, December 16, 2003 7:44 PM