Filter
Top Products
60
EN
USING THE REMOTE CONTROL UNIT
(cont.)
SELECT SCENES
4 Point the remote control at the camcorder’s
remote sensor. Press PLAY (
4
) and then press
R.A.EDIT ON/OFF or ON/OFF on the remote control.
The Random Assemble Editing Menu appears.
5 For GR-DVL820 Owners:
If using a Fade/Wipe at the beginning of the scene,
press FADE/WIPE on the remote control.
• Cycle through the effects by pressing repeatedly,
and stop when the one you want is displayed.
6 At the beginning of the scene, press EDIT IN/
OUT or IN/OUT on the remote control. The Edit-In
position appears in the Random Assemble Editing
Menu.
7 At the end of the scene, press EDIT IN/OUT or
IN/OUT. The Edit-Out position appears in the Random
Assemble Editing Menu.
8 For GR-DVL820 Owners:
If using a Fade/Wipe at the end of the scene, press
FADE/WIPE.
• Cycle through the effects by pressing repeatedly,
and stop when the one you want is displayed.
• If you select a Fade/Wipe effect for an Edit-Out
point, the effect is automatically applied to the
following Edit-In point.
• When you use Fade/Wipe effects, that time is
included in the total time.
9 For GR-DVL820 Owners:
If using Playback Special Effects, press EFFECT
(
੬ pg. 56).
10
Repeat steps 6 through 9 to register additional
scenes.
• To change previously registered points, press
CANCEL on the remote control. The registered
points disappear, one at a time, from the most
recently registered point.
• For GR-DVL820 Owners:
If you are not using Fade/Wipe or Program AE with
special effects, repeat steps 6 and 7 only.
NOTES:
● When choosing a scene, set Edit-In and Edit-Out points so that there is a relatively large difference between them.
● If the search time for an in-point exceeds 5 minutes, the recording deck’s Record-Standby mode will be canceled and
editing will not take place.
● If there are blank portions before or after the Edit-In and Edit-Out points, a blue screen may be included in the edited
version.
● Since time codes register time only as accurately as seconds, the time code total time may not match the total program
time exactly.
● Turning off the camcorder’s power erases all registered Edit-In and Edit-Out points.
For GR-DVL820 Owners:
● If you select Sepia or Monotone mode from Program AE with special effects, you cannot use the Black & White Fader.
In this case the Black & White indicator begins blinking. Once the next Edit-In point is registered, the effect is turned off.
To combine these effects, use Sepia or Monotone during recording, then use the Black & White Fader during Random
Assemble Editing.
● It is not possible to use Fade/Wipe effects and Program AE with special effects during Random Assemble Editing using
a DV cable.
1
2
3
4
5
6
7
8
––:–– ~
~
~
~
~
~
~
~
–
–
:
––
0
:
000
––
TOTAL
CODETIME
NIOUT
MODE
PLAY
R.A.EDIT
ON/OFF
EFFECT
FADE/WIPE
EDIT IN/OUT
CANCEL
REW
FF
ON/OFF
IN/OUT
Random Assemble
Editing Menu
Program
Remote sensor
RM-V717U
(Provided with
GR-DVL820 only)
RM-V700U
(optional)
OR