Filter
Top Products
72
EN
• During playback of the unrecorded
portion, High-speed Search and still
playback, LCD monitor indications
appear distorted. This is not a
defect.
• The speaker volume is too great.
• Since the analog input mode is
engaged, the camcorder is in the
Record-Standby mode.
————
————
————
• A malfunction of some kind has
occurred. In this case the
camcorder’s functions become
unusable.
————
• Turn the speaker volume down
(
੬ pg. 21).
• Set “S/AV INPUT” to “OFF” in the
Menu Screen
(
੬ pg. 48).
• Clean the video heads with an
optional cleaning cassette
(
੬ pg. 76).
• Wipe them gently with soft cloth.
Wiping strongly can cause damage
(
੬ pg. 74).
• Check the section of the manual
that explains LCD monitor/
viewfinder indications
(
੬ pg. 82 – 86).
• Remove the power supply (battery
pack, etc.) and wait a few minutes
for the indication to clear. When it
does, you can resume using the
camcorder. If the indication
remains even though you repeat
the above two or three times,
please consult your nearest JVC
dealer. Do not eject the cassette.
This will cause damage to the tape.
SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION
o The LCD monitor image is
distorted.
p Images on the LCD monitor
are jittery.
Q There is no playback
picture on the connected
TV.
W Blocks of noise appear
during playback, or there is
no playback picture and the
screen becomes blue.
E The LCD monitor, the
viewfinder and the lens
have become dirty (ex.
fingerprints).
R An unusual mark appears.
T An error indication
(E01, E02 or E06) appears.
TROUBLESHOOTING
(cont.)