Filter
Top Products
EN 71
SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION
10.
The tape is moving, but
there’s no picture.
11.
In the 5-Second mode,
recording ends before 5
seconds have elapsed.
12.
Snapshot mode cannot be
used.
13.
Digital Zoom doesn’t
work.
14.
P.AE/Effects and Fade/
Wipe Effects don’t work.
15.
The Black & White Fader
doesn’t work.
16.
The Dissolve function
doesn’t work.
17.
Scene transition does not
go as expected.
10.
•Your TV has AV input
terminals, but is not set to its
VIDEO mode.
•The cassette’s cover is open.
11.
•The 5-Second mode in the
System Menu is set to
“ANIM.”.
12.
•The Squeeze mode is
selected.
13.
•10X optical zoom is
selected.
•Picture Wipe or Dissolve are
being used in a scene
transition.
•5-Second recording was
done with the Power Dial set
to “5S”, and with “5SD”
selected in the System Menu.
•Snapshot was attempted
during Digital Zoom.
14.
•The Power Dial is set to “
A
”
or “5S”.
15.
•The Sepia or Monotone
effects are activated.
16.
•P.AE/Effect Sepia, Monotone
or Slow is activated.
•The Squeeze mode is
selected.
•The previously selected P.AE/
Effect was changed after the
last selected scene for
editing was registered.
17.
•When using “Picture Wipe/
Dissolve” (੬ pg. 37) or
“Dissolves during 5 second
mode recording”
(੬ pg. 26), there is a delay
of a fraction of a second
between the previous record
stop-point and the Dissolve
start-point. This is normal,
but this slight delay becomes
especially noticeable when
shooting fast-moving subject
or during rapid panning.
10.
•Set the TV to the mode or
channel appropriate for video
playback (੬ pg. 54 – 57).
•Close the cassette's cover
(੬ pg. 12).
11.
•Select “5S” or “5SD” in the
System Menu (੬ pg. 34).
12.
•Disengage the Squeeze
mode (੬ pg. 31).
13.
•Wait until the Picture Wipe
or Dissolve effects are
completed (੬ pg. 37).
•Change the setting of either
the System Menu or the
Power Dial (੬ pg. 33).
•Do not attempt to take a
Snapshot when performing
Digital Zoom (੬ pg. 28,
32).
14.
•Set the Power Dial to “
M
”
(੬ pg. 17).
15.
•Turn off Sepia and Mono-
tone (੬ pg. 42).
16.
•Turn off Sepia, Monotone or
Slow before adding
Dissolve to a scene
transition (੬ pg. 42).
•Make sure that the Squeeze
mode in the Recording
Menu is set to “OFF”
(੬ pg. 31).
•Make sure you have
selected the P.AE/Effects you
want before starting editing
(੬ pg. 42).
17.
————
CONTINUED ON NEXT PAGE