Filter
Top Products
EN 73
SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION
26.
•The optional headphones are
not connected to the head-
phones connector.
•The sound volume of the
headphones connector was
not adjusted appropriately. The
sound volume at this point is
the same as the level it was
adjusted to during playback.
27.
•“DISPLAY” is set to “OFF” in
the Date/Time Menu.
•Interface shooting is
performed.
28.
•“ON SCREEN” is set to
“OFF” in the Date/Time
Menu.
29.
•You have made the indica-
tors disappear.
30.
•In places subject to low
temperature, images become
dark due to the characteristics
of the LCD monitor. When
this happens, the displayed
colours differ from those that
are actually recorded. This is
not a defect of the camcorder.
•When the LCD monitor's
fluorescent light reaches the
end of its service life, images
on the LCD monitor become
dark. Consult your nearest
JVC dealer.
31.
•The light used to illuminate
the LCD monitor causes it to
become hot.
32.
•This may occur when the
surface or the edge of the
LCD monitor is pressed.
33.
•The speaker volume is too
great.
34.
————
26.
•Connect the optional
headphones to the head-
phones connector
(੬ pg. 76).
• Adjust the sound volume
during playback
(੬ pg. 49).
27.
•Set “DISPLAY” to “ON” in
the Date/Time Menu
(੬ pg. 11).
•During interface shooting,
the date/time does not
appear (੬ pg. 23).
•Press the IND.ON/OFF
button for longer than 1
second to make the
indicators appear
(੬ pg. 22).
28.
•Set “ON SCREEN” to “ON”
in the Date/Time Menu
(੬ pg. 25).
•Press the IND.ON/OFF
button for longer than 1
second to make the
indicators appear
(੬ pg. 22).
29.
•Press the IND.ON/OFF button
for longer than 1 second to
make the indicators appear
(੬ pg. 22).
30.
•Adjust the brightness and
angle of the LCD monitor
(੬ pg. 22, 23).
31.
•Close the LCD monitor to
turn it off or set the Power
Dial to “OFF”, and let the
unit cool down.
32.
————
33.
•Turn the speaker volume
down (੬ pg. 49).
34.
•Wipe them gently with soft
cloth. Wiping strongly can
cause damage.
26.
During recording, sound
cannot be heard.
27.
During recording, the
date/time does not appear.
28.
The indicators and
messages do not appear
on screen.
29.
The indicators do not
appear on the LCD
monitor or in the
viewfinder.
30.
Images on the LCD
monitor appear dark or
whitish.
31.
The rear of the LCD
monitor is hot.
32.
The indicators and the
image colour on the LCD
monitor are not clear.
33.
Images on the LCD
monitor are jittery.
34.
The LCD monitor and the
lens have become dirty
(ex. fingerprints).
CONTINUED ON NEXT PAGE