Filter
Top Products
66 EN
Audio Dub
Standby mode
6e
PAUSE
PLAY
A.DUB
STOP
MIC
USING THE REMOTE CONTROL UNIT
(cont.)
Audio Dubbing
The audio track can be customized only when recorded
in the 12-bit mode (੬ pg. 39).
NOTES:
●
Audio Dubbing is not possible on a tape recorded in
16-bit audio, on a tape recorded in the LP mode or on
a blank portion of a tape.
●
To perform Audio Dubbing while watching on the
television, make connections (
੬
pg. 22).
1
Play back the tape to locate the point where editing
will start, then press PAUSE (6).
2
While holding A.DUB (e) on the remote control,
press PAUSE (6). “6e” appears.
3
Press PLAY (
4
), then begin “narrating”.
Speak into the microphone.
•To pause dubbing, press PAUSE (6).
4
To end Audio Dubbing, press PAUSE (6), then STOP
(5).
To hear the dubbed sound during playback . . .
.... set “12BIT MODE” to “SOUND 2” or “MIX” in the
Menu Screen (੬ pg. 42, 44).
NOTES:
●
Sound is not heard from the speaker during Audio
Dubbing. To hear sound, connect optional headphones
to the AV OUT (headphone) connector (GR-DVX88/
DVX77 only).
●
When editing onto a tape that was recorded at 12-bit,
the old and new soundtracks are recorded separately.
●
If you dub onto a blank space on the tape, the sound
may be disrupted. Make sure you only edit recorded
areas.
●
If feedback or howling occurs during TV playback,
move the camcorder’s microphone away from the TV,
or turn down the TV’s volume.
●
If you change from 12-bit to 16-bit in mid-recording
and then use the tape for Audio Dubbing, it is not
effective from the point where 16-bit recording began.
●
During Audio Dubbing, when the tape moves to scenes
recorded in the LP mode, scenes recorded in 16-bit
audio or a blank portion, Audio Dubbing stops
(
੬
pg. 91).
Speaker
Display
AV OUT
(headphone) connector
(GR-DVX88/DVX77
only)
Stereo microphone
Remote
sensor
Located
beneath
the cover.
GR-DVX88/
DVX77 only