Filter
Top Products
EN73
R.A.EDIT
ON/OFF
1
2
3
4
5
6
7
8
––: –– ~
~
~
~
~
~
~
~
––
NIOUT
MODE
ROSYNCH
O.1
–
–
–
:
––
0
:
000
TOTAL
CODETIME
For More Accurate Editing
Some VCRs make the transition from Record-Pause to
Record mode faster than others. Even if you begin editing
for the camcorder and the VCR at exactly the same time,
you may lose scenes you wanted, or find that you have
recorded scenes you did not want. For a cleanly edited
tape, confirm and adjust the timing of the camcorder
against your VCR.
DIAGNOSING VCR/CAMCORDER TIMING
1
Play back the tape in the camcorder, then point the
remote control at the camcorder’s remote sensor
and press R.A.EDIT ON/OFF.
Random Assemble Editing Menu appears.
2
Perform Random Assemble Editing on Program 1
only. In order to check VCR and camcorder timing,
select the beginning of a scene transition as your
Edit-In point.
3
Play back the dubbed scene.
•If any images from the scene prior to the
transition you chose for your Edit-In point were
recorded, that means your VCR moves too quickly
from Record-Pause to Record mode.
•If the scene you tried to dub starts in progress, the
VCR is slow to start recording.
Random Assemble
Editing Menu
Program 1
Remote sensor
ADJUSTMENT OF VCR/CAMCORDER
TIMING
4
Point the remote control at the camcorder’s remote
sensor and press R.A.EDIT ON/OFF to make the
Random Assemble Editing menu disappear, then
press the MENU Wheel in. The Menu Screen
appears.
5
Rotate the MENU Wheel to select “ VIDEO” and
press it. The VIDEO Menu appears. Then, rotate it to
“SYNCHRO” and press it. The value for
“SYNCHRO” is highlighted.
6
Based on the diagnostics performed, you can now
advance the VCR’s record timing by rotating the
MENU Wheel towards “+”. You can also delay the
VCR’s record timing by rotating the MENU Wheel
towards “–”. The adjustment range is from –1.3 to
+1.3 seconds, in 0.1-second increments.
Press the MENU Wheel to finish the setting.
7
Rotate the MENU Wheel to select “ RETURN” and
press it twice.
Now perform Random Assemble Editing beginning
with step 4 on page 71.
NOTES:
●
Before performing actual Random Assemble
Editing, do a few Random Assemble Editing
trial runs to check whether the value you
have input is appropriate or not, and make
adjustments accordingly.
●
Depending on the recorder, there may be
situations where the timing difference
cannot be fully corrected.
VIDEO Menu
GR-DVX88/DVX77
only