Filter
Top Products
E-77
1.
Turn the AUDIO LEVEL controls.
The audio recording level of CH-1 channel is adjusted with the
CH-1 AUDIO LEVEL control, and the CH-2 channel is adjusted
with the CH-2 AUDIO LEVEL control.
The recording level is raised when the control is turned clockwise.
● Adjust the level while observing the audio level meter on the
LCD screen or the viewfinder screen and/or monitoring the
sound.
The monitor sound is output from the EARPHONE jack (
☞
See page 51.)
Ⅲ To return to the automatic audio recording level adjustment
mode, use either of the following methods.
● Set the CH1 AUDIO LEVEL or CH2 AUDIO LEVEL item on the
OPERATION menu screen to AUTO
or
● Set the MODE item to AUTO on the TOP MENU screen.
In this case the shooting mode becomes the auto mode.
AUDIO
LEVEL
CH-1 CH-2
2. Adjusting the Audio Recording Level Manually
AUDIO LEVEL
controls
● The standard level for recording
audio on the tape is –12 dB.
If a tape recorded on the GY-
DV300 is played back on VCR
whose audio standard level is –
20dB, the sound will be very
loud.
If a tape recorded on other VCR
whose audio standard level is
–20dB is played back on GY-
DV300, the sound will be very
low.
The audio level meter is displayed
by setting the AUDIO LEVEL item
on the DISPLAY [2/2] menu screen
to ON.
Reducing the Wind Noise of the Microphone
SYSTEM [1/2] menu screen Set the WIND CUT MIC1 or WIND CUT MIC2 item on the SYSTEM
[1/2] menu screen to ON.
WIND CUT MIC1 Set to ON to reduce the wind noise of the
built-in microphone or a microphone
connected to the MIC 1 input connector.
WIND CUT MIC2 Set to ON to reduce the wind noise of a
microphone connected to the MIC 2 input
connector.
MIC1 INPUT SEL
STSY EM 1 / 2
][
IT
N
WIND C
U
TMIC1
WIND C
U
TMIC2
O
N
O
N
O
FF
+
48V MI
C1
O
FF
+
48V MI
C2
AUDIO
MOD
E
4
8K
REC MO
D
E
S
P
LONG P
A
USE T IME
30
MIN
NEXT P
A
GE
PAGE B
A
CK