Filter
Top Products
54 EN
REFERENCES
MasterPage: Body_Left
Images on the LCD monitor appear dark or
whitish.
● In places subject to low temperature, images
become dark due to the characteristics of the
LCD monitor. This is not a malfunction.
HAdjust the brightness and angle of the LCD
monitor. (੬ pg. 9, 18, 49)
● When the LCD monitor's fluorescent light reaches
the end of its service life, images on the LCD
monitor become dark.
HConsult your nearest JVC dealer.
Colored bright spots appear all over the LCD
monitor.
● The LCD monitor is made with high precision
technology. However, black spots or bright spots
of light (red, green or blue) may appear constantly
on the LCD monitor. These spots are not
recorded on the picture. This is not due to any
defect of the unit. (Effective dots: more than
99.99 %)
The SD card cannot be removed from the
camera.
HPush in the SD card a few more times. (੬ pg. 19)
Picture does not appear on the LCD monitor.
● The LCD monitor's brightness setting is too dark.
HAdjust the brightness of the LCD monitor.
(੬ pg. 18, 49)
The following indications appear on the screen.
(Battery indicator)
Displays the battery remaining power.
Remaining power level
● As the battery power comes close to nil, the
battery indicator blinks. When the battery power
is exhausted, power turns off automatically.
SET DATE/TIME!
● Appears when the date/time is not set. (੬ pg. 18)
● Appears when the built-in clock (lithium) battery is
discharged and the previously set date/time is
erased. (੬ pg. 18)
LENS CAP
Appears for 5 seconds after power is turned on
with the power switch set to , if the lens cap is
attached or when it is dark.
PLEASE INSERT MEMORY CARD!
Appears when no SD card is inserted in the SD
slot. (੬ pg. 19)
HARD DISK DRIVE IS NOT FORMATTED
Appears when the built-in hard disk needs to be
formatted.
THIS CARD IS NOT FORMATTED
Appears when an unformatted SD card is
inserted.
HARD DISK DRIVE IS FULL
Appears when the built-in hard disk is full and
recording is not possible.
MEMORY IS FULL
Appears when the SD card is full and recording
is not possible.
HDD ERROR!
MEMORY CARD ERROR!
Appears when some errors occured with the
recording media.
● Remove the card once and insert it again. If
the error is not cancelled, replace the card with
one that has been guaranteed for correct
operation. (੬ pg. 19, 62)
● Perform clean up to restore the capacity of the
recording media. (੬ pg. 40)
● It is recommended to run check disk regularly
on the PC, on condition that there is no data on
the hard disk of the camera.
Warning Indications
ExhaustedHigh
M5E6US.book Page 54 Tuesday, September 27, 2005 5:42 PM