Filter
Top Products
EN
44
INDEX
WARNING INDICATIONS
(high) (exhausted)
Displays the battery remaining power level. As the
battery power comes close to nil, the battery indicator
blinks (battery power warning). When the battery
power is exhausted, power turns off automatically.
Appears when no tape is loaded. (੬ pg. 9)
CHECK TAPE’S ERASE PROTECTION TAB
Appears when the erase protection tab is set to “SAVE”
while the Power Switch 8 is set to “ ” or “ ”.
(੬ pg. 9)
HEAD CLEANING REQUIRED USE CLEANING
CASSETTE
Appears if dirt is detected on the heads during
recording or playback. Use an optional cleaning
cassette. (੬ pg. 38)
CONDENSATION, OPERATION PAUSED
PLEASE WAIT
Appears if condensation occurs. When this indication is
displayed, wait more than 1 hour until condensation
disappears.
TAPE!
Appears if a tape is not loaded when the Recording
Start/Stop Button 7 or SNAPSHOT Button 5 is
pressed while the Power Switch 8 is set to “ ” or
“ ”.
TAPE END
Appears when the tape ends during recording or
playback.
SET DATE/TIME!
•Appears when the date/time is not set. (੬ pg. 10)
•Appears when the built-in clock (lithium) battery is
discharged and the previously set date/time is erased.
(੬ pg. 38)
LENS CAP
Appears for 5 seconds after power is turned on if the
lens cap is attached.
A. DUB ERROR!
Appears if Audio Dubbing is attempted on a blank
portion of a tape. (੬ pg. 29)
A. DUB ERROR!
<CANNOT DUB ON A LP RECORDED TAPE>
<CANNOT DUB ON A 16BIT RECORDING>
<CHECK TAPE’S ERASE PROTECTION TAB>
•Appears if Audio Dubbing is attempted on a tape
recorded in the LP mode.
•Appears if Audio Dubbing is attempted on a tape
recorded in 16-bit audio.
•Appears if A. DUB (e) h on the remote control is
pressed when the erase protection tab is set to
“SAVE”.(੬ pg. 29)
INSERT ERROR!
Appears if Insert Editing is attempted on a blank
portion of a tape. (
੬ pg. 29)
INSERT ERROR!
<CANNOT EDIT ON A LP RECORDED TAPE>
<CHECK TAPE’S ERASE PROTECTION TAB>
•Appears if Insert Editing is attempted on a tape
recorded in the LP mode.
•Appears if INSERT (w) g on the remote control is
pressed when the erase protection tab is set to
“SAVE”.(੬ pg. 29)
E01, E02 or E06 UNIT IN SAFEGUARD MODE
REMOVE AND REATTACH BATTERY
The error indications (E01, E02 or E06) show what type
of malfunction has occured. When an error indication
appears, the camcorder turns off automatically.
Remove the power supply (battery, etc.) and wait a few
minutes for the indication to clear. When it does, you
can resume using the camcorder. If the indication
remains, consult your nearest JVC dealer.
E03 or E04 UNIT IN SAFEGUARD MODE EJECT
AND REINSERT TAPE
The error indications (E03 or E04) show what type of
malfunction has occured. When an error indication
appears, the camcorder turns off automatically. Eject
the cassette once and re-insert it, then check if the
indication clears. When it does, you can resume using
the camcorder. If the indication remains, consult your
nearest JVC dealer.
01 DX55/45/35/25EK_EN 34-48 03.1.23, 3:41 PM44