Filter
Top Products
18 EN
RECORDING
Basic Recording (cont.)
Shooting While Watching The LCD Monitor
Before the following steps, perform step 1 (੬ pg. 16).
2
ENTER RECORD–STANDBY MODE
Make sure the viewfinder is fully tilted downward
and pushed back in. Set the Power Switch to the
camera position (“ ”, “ ”, “5S” or “ ”) while
pressing down the Lock Button located on the switch.
Press PUSH-OPEN and open the LCD monitor fully.
•The lens cover opens, the power lamp lights and the
camcorder enters the Record-Standby mode.
•The scene you are aimed at appears in the LCD
monitor, with the word “PAUSE” superimposed
upon it.
3
START SHOOTING
Tilt the LCD monitor upward/downward for best
viewability (੬ pg. 19) and press the Recording Start/
Stop Button.
•“ ” appears in the LCD monitor while recording
is in progress.
4
STOP RECORDING
Press the Recording Start/Stop Button again to stop
recording.
•The camcorder re-enters the Record-Standby mode.
NOTES:
●
When you use the LCD monitor outdoors in direct
sunlight, the LCD monitor may be difficult to see. If this
happens, we recommend that you use the viewfinder
(
੬
pg. 16).
●
To turn the tally lamp off during recording, refer to
pgs. 30 and 32.
●
For other notes, refer to pg. 17.
5S
P
L
A
Y
O
F
F
180°
90°
Power Switch
Recording Start/Stop Button
Power lamp
Lock Button
PUSH-OPEN Button
Tally lamp
(lights while recording
is in progress)