Filter
Top Products
72 EN
TROUBLESHOOTING
(cont.)
SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION
37.
Play, Rewind and Fast-Forward
functions do not work.
38.
The tape is moving, but there
is no picture.
39.
The LCD monitor indications
are distorted.
40.
Images on the LCD monitor
are jittery.
41.
The LCD monitor, the
viewfinder and the lens have
become dirty
(ex. fingerprints).
42.
An unusual mark appears.
43.
An error indication
(E01 — E06) appears.
44.
The charger indicator on the
AC Power Adapter/Charger
does not light.
45.
The recording mode indicator
“LP” blinks.
46.
Picture does not appear on the
LCD monitor.
47.
When the image is printed
from the printer, a black bar
appears at the bottom of the
screen.
48.
The power lamp blinks.
37.
• The Power Switch is not set to
“
”.
38.
• Your TV has AV input terminals,
but is not set to its VIDEO mode.
• The cassette’s cover is open.
39.
• During playback of the
unrecorded portion, High-speed
Search and still playback, LCD
monitor indications appear
distorted. This is not a defect.
40.
• The speaker volume is too great.
41.
————
42.
————
43.
• A malfunction of some kind has
occurred. In this case the
camcorder’s functions become
unusable.
44.
• The temperature of the battery is
extremely high/low.
• Charging is difficult in places
subject to extremely high/low
temperatures.
45.
• This occurs when recording in
the LP mode is not available.
After the indicator blinks, the
recording mode switches to
“SP” and recording goes on.
46
• The viewfinder is pulled out.
• The LCD monitor's brightness
setting is too dark.
47.
• This is not a malfunction.
48.
• The camcorder was turned on
when the battery power was
almost gone.
37.
• Set the Power Switch to “ ”
(
੬ pg. 45).
38.
• Set the TV to the mode or
channel appropriate for video
playback (
੬ pg. 50, 51).
• Close the cassette's cover
(
੬ pg. 11).
39.
————
40.
• Turn the speaker volume down
(
੬ pg. 45).
41.
• Wipe them gently with soft
cloth. Wiping strongly can
cause damage.
42.
• Check the section of the manual
that explains LCD monitor/
viewfinder indications
(
੬ pg. 76, 77).
43.
• Remove the power supply
(battery pack, etc.) and wait a
few minutes for the indication to
clear. When it does, you can
resume using the camcorder.
If the indication remains even
though you repeat the above
two or three times, please
consult your nearest JVC dealer.
44.
• To protect the battery, it is
recommended to charge it in
places with a temperature of
10°C to 35°C (50°F to 95°F)
(
੬ pg. 79).
45.
————
46.
• Push the viewfinder back in.
• Adjust the brightness of the LCD
monitor (
੬ pg. 19).
• If the monitor is tilted upward
180 degrees, open the monitor
fully (
੬ pg. 25).
47.
• By recording with “DIS”
activated (
੬ pg. 31) this can be
avoided.
48.
• Replace with a charged battery
pack (
੬ pg. 8, 9).