Filter
Top Products
EN71
4
567
USER MAINTENANCE
After Use
1
Turn off the camcorder.
2
Slide OPEN/EJECT in the direction of the arrow, then
swing the cover open until it locks. The cassette
holder opens automatically. Remove the cassette.
3
Press “PUSH HERE” to close the cassette cover.
4
Press the Battery Release Button and remove the
battery pack.
Cleaning The Camcorder
1
CLEAN EXTERIOR
Wipe gently with a soft cloth.
•Put cloth in diluted mild soap and wring it well to
wipe off heavy dirt. Then wipe again with a dry
cloth.
2
CLEAN LCD MONITOR
Press PUSH-OPEN and open the LCD monitor. Wipe
gently with the provided cleaning cloth or a commer-
cially available soft cloth. Be careful not to damage
the monitor. Close the LCD monitor.
3
CLEAN LENS
Blow it with a blower brush, then wipe gently with
lens cleaning paper.
4
PULL OUT VIEWFINDER FULLY
5
TILT VIEWFINDER VERTICALLY
Tilt the viewfinder upward to 90 degrees.
6
OPEN COVER
Open the cover located on the bottom of the
viewfinder.
7
CLEAN VIEWFINDER
Remove dust using a blower brush.
8
PUSH VIEWFINDER BACK IN
Close the cover until it locks in place. Tilt the
viewfinder horizontally, and push it back in.
NOTES:
●
Avoid using strong cleaning agents such as benzine or alcohol.
●
Cleaning should be done only after the battery pack has been removed or other power units have been
disconnected.
●
Mould may form if the lens is left dirty.
●
When using a cleaner or chemically treated cloth refer to the cautions of each product.
Battery Release
Button
Remove.
OPEN/EJECT Switch
PUSH HERE
Cover
PUSH-OPEN Button
Blower brush