Filter
Top Products
28
HOME MOTION DETECT Screen
Item
MODE
LEVEL
AREA EDIT..
ALARM DISPLAY
DEMONSTRATION
Initial Value
OFF
NORMAL
–
5s
–
Function & Setting
Turns the motion detect function on and off.
OFF : Defeats this function.
ON : Activates this function.
Sets the level at which motion is identified.
When the item “MODE” is set to “OFF”, this item does not work and “---” is dis-
played as the item name in the HOME MOTION DETECT Screen.
• To detect motions characterized by large changes in the signal level
: Decrease the setting value.
• To detect motions characterized by small changes in the signal level
: Increase the setting value.
Setting values : -5 to NORMAL to 5
Sets of the area of the picture within which the motion detect function operates.
☞
P. 36, “HOME MOTION DETECT Setup”
Sets the length of an alarm signal and the alarm display output when
motion is detected.
When the item “MODE” is set to “OFF”, this item is does not work and “---” is dis-
played as the item name in the HOME MOTION DETECT Screen.
Setting values : OFF, 5s, 6s, 7s, 8s, 10s, 15s, 20s, 30s, 60s
This function is used to confirm the setup of the motion detect function.
When the camera is in the home position:
This screen sets the motion detect function, which outputs an alarm signal when motion is detected in the monitored picture. The
alarm signal is output from the alarm output terminal on the terminal board.
When the item “MODE” is set to OFF, an alarm signal is output from the alarm output termi-
nal but the alarm display is not shown in the picture.
MEMO
CAUTION
This item is invalid with the system using the RM-P2580. When using the RM-P2580, use
item “ALARM TIME” instead.
When the setting value of the detection level is increased, it sometimes causes the fluores-
cent lamp to flicker.
Check the performance at the DEMONSTRATION item after changing the setting.
MEMO
Initial Value
Function & Setting
Setting Up the Camera Using an RM-P2580
Item
MEMO
If the IR setting is used under ordinary sunlight or fluorescent light, the switching between
the color and B&W modes will not be performed correctly.
● Demonstration function is invalid when the camera is in a position other than the home position.
● The motion detect function is not activated when the camera is panned, tilted or zoomed in the home position.
● When the iris or focus operation is performed while the camera is in the home position, the motion detect function is not activated for 5 seconds
after completion of the operation.
● During auto patrol, the motion detect function cannot be activated even when the camera is in the home position.
MEMO
Use this function to set the type of light illuminating the object in the B&W mode.
NORMAL : Setting for normal lighting.
IR : Setting for using IR lighting.
B&W/COLOUR
MODE
..
LIGHT TYPE
NORMAL
CAMERA ALC screen (Continued)
TK-C676-C655 in_LWT0200-001A-H 04.6.22, 9:30 AM28