Filter
Top Products
11
Set the camera in the following procedure.
Preparation Procedure
❈ If multiple PCs are in use, first turn on the power for one PC and proceed to Other
Settings with V.Networks Setup Tool. Only then, turn on the power to a second PC
and go on to Other Settings with V.Networks Setup Tool. Repeat the procedure for
other PCs. Refer to the PDF instruction manual inside the supplied CD-ROM.
Step 2 Setting the Network
Install the software [V.Networks Controller], and set the network for the PC
and VN-C11. Also perform the setting with [V.Networks Setup Tool] and regis-
tration of the connected camera with [V.Networks Controller].
Step 3 Adjusting the Camera
Adjust the back-focus while checking images.
Step 5 Operations with V.Networks Controller
Now the camera is ready for recording and playback, etc. with [V.Networks
Controller].
Step 6 Operations with a Web Browser
The camera is ready for Web operations.
Step 4 Setting with V.Networks Controller
Set image quality and alarm, etc. by using [V.Networks Controller] which has
been installed.
Step 1 Connection and Installation
Attach a lens and connect the power cable, a LAN cable and an alarm etc.
Then, install the camera to a fixer, etc. Fix a wire securely for preventing the
camera from falling off.
After installing the camera, connect the MONITOR OUT terminal located on
the rear panel to the monitor TV and adjust the camera angle.
(For back-focus adjustment,
☞ Page 24)
☞ Page 12
☞ Page 16
☞ Page 24
☞ Page 25
☞ Page 27
☞ Page 28
VN-C10_E_01-24.pm6e 03.4.24, 10:02 AM11