Filter
Top Products
25
Starting Up V.Networks Controller
Operations (Step 4 Setting with V.Networks Controller)
With the installed Controller, camera images can be monitored. The settings for
recording, replay and frame rate etc. can also be performed.
1.
Select [Start], [Programs], [V.NETWORKS] and then [V.Networks Controller] to start
up [V.Networks Controller].
Live images from the camera are dis-
played.
Note
• If a password has been set, enter the correct password.
• This [Controller] can be connected to VN-C1, VN-C2, VN-C3, VN-C30 (only for JPEG), VN-
A1, VN-C10 and VN-C11.
• In the MPEG4 mode, up to 4 clients can be connected at one time. If 5 or more clients are
connected, the message “The VN-C11U has not start the Streaming Service.” appears.
In the pull down menu, select the camera
to connect.
Caution
After the power for VN-C11 is turned
on, there will be about 20 seconds until
VN-C11 becomes ready to be con-
nected with the PC. This is not a de-
fect.
VN-C10_E_25-32.pm6e 03.4.24, 10:01 AM25