Filter
Top Products
The Basics
53
Contents
Back
Next
Index
Disconnecting the DCS 645 from the
Camera Body
1 Place the camera on a table or other flat
surface.
2 If the DCS 645 is being powered by battery,
remove the battery.
If the DCS 645 is being powered by AC
adapter, disconnect the AC adapter.
3 Remove the IEEE 1394 cable (page 78) if it is
connected.
4 Rotate the DCS 645 Release button to the left
and press, then pivot the top of the camera
body away from the DCS 645.
5 Carefully remove the DCS 645 from the
camera body.
Connecting Flash/Strobe Units
Connect flash and studio strobes following the
instructions in your camera body's manual.
DCS 645
Release
button