Kodak Picture Frame Digital Photo Frame User Manual


 
7
27
Before installing this equipment, users should ensure that it is permissible to
be connected to the facilities of the local telecommunications company. The
equipment must also be installed using an acceptable method of connection. In
some cases, the inside wiring of a building or home associated with a single
line of service may be extended by means of a certified connector assembly
(telephone extension cord).
The customer should be aware that compliance with the above conditions may
not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian
maintenance facility designated by the supplier. Any repairs or alterations
made by the user to this equipment, or equipment malfunctions, may give the
telecommunications company cause to request the user to disconnect the
equipment.
Users should ensure for their own protection that the electrical ground
connections of the power utility, telephone lines, and internal metallic water
pipe system, if present, are connected together. This precaution may be
particularly important in rural areas.
WARNING! Users should not attempt to make such connections
themselves, but should contact the appropriate
electric inspection authority, or electrician, as
appropriate.
Notice: The LOAD NUMBER (LN) assigned to each terminal device denotes the
percentage of the total load to be connected to a telephone loop which is used
by the device to prevent overloading. The termination on a loop may consist of
any combination of devices subject only to the requirement that the sum of the
LOAD NUMBERS of all of the devices does not exceed 100.
SmartPictureFrameNon-Networked.book Page 27 Tuesday, October 9, 2001 4:36 PM