Filter
Top Products
12
FILL
1. Press the ON/OFF BUTTON (2) to open the
lens cover and to turn the camera ON.
2. Press the SELECT/FLASH BUTTON (20)
repeatedly until the RED-EYE-REDUCTION
INDICATOR (26) appears on the
LCD PANEL (11).
• Disregard step 2 if the default setting is
already set for red-eye reduction.
3. Frame your picture in the VIEWFINDER
EYEPIECE (10).
4. Press the SHUTTER BUTTON (1) to take
the picture.
Auto flash without
red-eye reduction
Use this mode for taking pictures without
people. You can change the default setting to
auto flash without red-eye reduction by
following the instructions below:
1. Press the ON/OFF BUTTON (2) to open the
lens cover and to turn the camera ON.
2. Press the SELECT/FLASH BUTTON (20)
repeatedly until the AUTO-FLASH
INDICATOR (32) appears on the
LCD PANEL (11).
3. Frame your picture in the VIEWFINDER
EYEPIECE (10).
4. Press the SHUTTER BUTTON (1) to take
the picture.
• The camera will now default to the auto-
flash mode without red-eye reduction.
Fill flash
When bright light indoors or outdoors comes
from behind the subject (backlighting), dark
shadows (especially on faces) may occur.
Use fill flash to lighten these shadows.
1. Press the ON/OFF BUTTON (2) to open the
lens cover and to turn the camera ON.
2. Press the SELECT/FLASH BUTTON (20)
repeatedly until the FILL-FLASH
INDICATOR (30) appears on the
LCD PANEL (11).
3. Frame your subject within the VIEWFINDER
EYEPIECE (10).
4. Partially depress the SHUTTER BUTTON (1).
When the FLASH/CAMERA-READY LAMP (9)
glows green, fully depress the shutter
button to take the picture.