Filter
Top Products
Troubleshooting and support
www.kodak.com/go/support
68
I didn’t connect to my network the first time I turned on my frame. Can I
do it now?
Yes, you can.
1 Tap Home
→ Settings . Slide to highlight Network, then tap Select.
2 Highlight Scan for wireless networks, then tap OK.
3 Continue with step 1 on page 5.
Picture frame problems
If... Try one or more of the following
Frame cannot connect
to the wireless network
—“Wireless network
not found” appears.
■ Make sure you have a wireless router and that it is broadcasting
the SSID, or enter the SSID manually.
■ Make sure you are within the operating range of the network.
Move the frame into the same room with the router.
■ Make sure your frame is using the latest firmware. Check
www.kodak.com/go/digitalframesupport for updates.
■ If your network security is enabled (See page 8), enter your security
key (WEP or WPA). The person who set up your network can help
you with this information.
Frame does not
turn on.
■ Make sure the power cable that was included with your frame is
connected securely (see page 2).
■ Unplug the power cable for 5 seconds, then reconnect the cable.
Press and hold the power button (for about 2 seconds), then
release.