4
4. Taking Pictures
Note: The LCD monitor cannot be used as a viewfinder. Use the optical viewfinder when taking
pictures.
1 Set the main switch on the side of the camera to REC.
(Figure 1)
The LED indicator will light green after blinking red.
The status LCD will display the number of pictures that
can be taken. (Figure 2)
2 Arrange your picture in the viewfinder and press the shut-
ter button.
The camera will take a picture with a beep tone. You can
continue taking pictures until the status LCD shows “0”.
Note:When there is no memory left for taking pictures, the camera will not shoot and no beep
will be heard when the shutter button is pressed. Transfer any recorded images you wish
to keep to the computer and then erase them to make space for more pictures.
(Figure 1)
(Figure 2)
Important – Please Read Before You Begin
● Battery life
Number of pictures about 100
Continuous Playback time about 30 min.
Note: The above figures are based on tests carried out by Konica understandard condi-
tions (one picture every 30 seconds, including erase operations). The actual bat-
tery life, however, depends on the type and manufacturer of the batteries used.
● If the camera is left idle for about two minutes with the main switch set to REC or PLAY, it
will turn off automatically. (To resume operation, set the main switch to OFF and then to
REC or PLAY again.)
Battery Exhaustion
The LED indicator will change from green to yellow-orange when the batteries are almost ex-
hausted.
When this happens, replace the batteries promptly.
OFF RECPLAY