Filter
Top Products
5352
FOR OWNERS OF THE QUARTZ-DATE MODEL
3.Point the remote control toward the
front of the camera and press either
the release button (•) or the delay
button (2s) to take the picture.
• If the release button (•) is pressed, the self-
timer/remote-control lamp on the front of the
camera will blink once before the picture is
taken. If the delay button (2s) is pressed, the
lamp will blink for two seconds before the
picture is taken.
ADVANCED OPERATION
•To save power, the camera automatically shuts down if the shutter is not released in
approximately 8 minutes.
• Under fluorescent or extremely bright lighting, or with backlit subjects, the remote control
may not operate or the effective distance may be reduced.
• The remote control mode will remain in effect after the picture has been taken. Press the
drive-mode button to reset the drive mode, or turn the camera off.
CHANGING THE REMOTE-CONTROL BATTERY
The remote control uses a 3V lithium battery (CR2032).
When pressing the remote-control buttons does not
release the shutter, the battery needs to be replaced.
The supplied battery should be sufficient for
approximately ten years of operation.
1.Pull out the battery chamber as shown and
remove the old battery.
2.Insert a new battery into the battery chamber
with the positive (+) pole up.
3.Slide the battery chamber into the remote
control.