Filter
Top Products
165mm+-2
122mm+-2
14
15
Icon Index Table
Working Mode
Focus Range
Flash Modes
Digital Zoom
Thumbnails
Self-timer
Movie Clip
Memory Card Inside
Battery Status
Image Size (Resolution)
Image Quality
White Balance
Exposure
Protected Image
Print (DPOF)
Voice Memo
Darkness Warning
X1
AUTO
+
+
-
0
X4
Overall Introduction
Switch On or Off the Camera
Loading the Batteries
Getting Ready
Slide the "POWER" switch sideways and
hold it awhile to switch on the camera.
Repeat the action above to switch off the
camera.
1. Check if the camera is switched off.
2. Slide the Battery / Memory Card Cover out to open it.
3. Load 2 x AA batteries into the battery chamber, following the
polarity indications.
4. Close the Battery / Memory Card Cover.
Note
The symbols below are used to indicate the battery status on the TFT LCD
monitor.
( ):Battery power is full.
( ):Battery power is half drained. Have new batteries ready.
( ):Battery power is drained. Replace the batteries you are using now.
Note
The battery type shown below is recommended to ensure the normal operation
of the camera.
Brand Type
Duracell(Ultra) Alkaline