Konica Minolta T3 Digital Camera User Manual


 
Flash Synchronization for KONICA Autoreflex-T3
O - Synchronized X - Not synchronized
3. Determine the Exposure: Flash bulbs are coupled to all
shutter speeds. Electronic flash are synchronized with shutter
speeds of up to 1/125 sec. AEC photography is impracticable
in flash photography in which flashes are used as the main
lighting source. Here, your camera must be set to manual. In
general, the aperture value is determined by dividing the
guide number of the flash bulb or electronic flash with the
taking distance.
For example, when the guide number of your electronic flash
is 64 with ASA 80/125 and the taking distance is 8 feet, the
equation will be 64 : 8 = 8. The correct exposure may be
obtained with the aperture set to f/8.
3. Einstellung der Belichtungszeit: Blitzbirnen sind bei allen
Verschlußzeiten gekuppelt (M-Kontakt). Elektronenblitzge-
räte können bis zu einer Verschlußzeit von 1/125 sec
verwendet werden (X-Kontakt). Wird das Blitzlicht als
Hauptlichtquelle verwendet, so schaltet man die Belichtung-
sautomatik ab und stellt den Blendenwert von Hand ein. Den
korrekten Blendenwert erhalten Sie, wenn Sie die Leitzahl
(siehe Angaben des Blitzgeräteherstellers) durch die Auf-
nahme-Entfernung dividieren.
Ist die Lietzhal z.B. 20 und die Entfernung 5 m, so müssen
Sie mit Blende 4 belichten. Die Leitzahl ist von der Helligkeit
des Blitzgerätes und der Empfindlichkeit des Films abhängig.
3. Déterminer l'exposition: Les ampoules de flash sont
couplées à toutes les vitesses d'obturation. Les flashs électro-
niques sont synchronisés avec les vitesses jusqu'à 1/125 de
sec. Le système AEC n'est pas utilisable avec flash, celui-ci
fonctionnant comme unique source d'éclairage. Avec le flash,
l'appareil doit être réglé manuellement. En général, l'ouver-
ture s'obtient en divisant le nombre guide de l'ammoule
utilisée ou du flash électronique par la distance de prise.
Par exemple, si le nombre-guide du flash est de 20 à ASA
80/125 et que la distance soit de 5 m, l'ouverture sera de f/4
(20:5=4).
3. Bestäamning av exponeringsvärden: Blixtlampor kan an-
vändas till alla slutarhastigheter. Elektronblixtens är
synkroniserade med slutarhastigheter upp till 1/125 sek
AEC-fotografering är omöjlig vid blixtfotografering där
blixtar används som huvudljuskälla. I detta fall måste
kameran ställas in på manual. I allmänhet bestämmes
bländaren genom att dividera blixtlampans eller elektronblix-
tens ledtal med avståndet.
Om till exempel, elektronblixtens ledtal är 20 vid ASA 100
och avståndet är 5 meter, far man 20 : 5 = 4 den riktiga
exponeringen erhålles med bländaren satt på f/4.
62