Filter
Top Products
Installation
In this manual, "User" refers to whoever has access to the Network Camera, and "Administrator"
refers to the person who can configure the Network Camera and grant user access to the camera.
Hardware installation
Please verify that your product package contains all the
accessories listed in the foregoing Package Contents.
Depending on the user’s application, an Ethernet cable may be
needed. The Ethernet cable should meet the specs of UTP
Category 5 and not exceed 100 meters in length.
To install in Ethernet
Make sure the Ethernet is firmly connected to a switch hub. After attaching the Ethernet cable plug
in the power adapter. If the LED turns out to blink orange-color, go to next paragraph “Software
installation”.
This Network Camera provides a general I/O terminal block with one digital input and one digital
output device control. The pin definition is as below.
Consult with the dealer of the peripherals for correct installation.
1 SW_NOPEN OUTPUT (Max. 400mA, 12VDC ±5%)
2 SW_COMMON OUTPUT (open from SW_OPEN at
initial state) (close with SW_OPEN when set DO to ON)
3 DI+ INPUT (Max. 50mA, 12VDC)
4 DI- INPUT (Initial state of DI is low)