Filter
Top Products
Selecting the Data to be Superimposed (select "Func")
There are two data modes which will superimpose information onto the film. If you do
not desire to superimpose any information, this function may also be switched off.
1. Set the shutter release mode selector lever to
"S" (to turn the power on).
2. Press the “F1” Key for about 2 seconds to
display "Func" on the main LCD panel, then
press the “F1” Key again.
3. Use the front and rear dials to select the data to be superimposed (DATA or DAY).
The mode of data to be superimposed changes when the front or rear dial is turned
clockwise.
Data superimpose modes
DATA:
The exposure mode, aperture, shutter speed, exposure
compensation value, exposure metering mode and index
number are superimposed.
DAY:
The date (year, month and day), time and index number are
superimposed.
OFF:
The data superimpose function is turned off.
4. Display the desired data superimpose mode on the external liquid crystal display
panel, then press the “SET” Button for about 2 seconds. The setting is registered
and the desired data superimpose mode is displayed on the main LCD panel.
Checking the data to be superimposed
The data to be superimposed switches in the following order each time the “SET”
Button is pressed:
Date (year, month and day)
-
Time
-
Index number
*The display on the main LCD panel returns to normal when the shutter release
button is half-pressed or when another priority button is pressed.
This illustration is for explanatory purposes. The actual display may differ.
75
76