Filter
Top Products
Removing a partially exposed film roll
To remove partially exposed film roll, insert the
dark slide in the magazine and press the shutter
button and the forced film advance button “A”
simultaneously. This causes the film to be taken
up till the end and the magazine's LCD panel
shows "End".
6-exposure film
If you continue photographing after the 8th exposure when using 6-exposure film, the
shutter membrane may be damaged by the leader paper at the film end or by the film's
sticker. Use the procedure described below.
Photograph in the same way as with 120 film. Eight exposures can be taken. After
taking the 8th exposure, insert the dark slide in the magazine,
then half-press the shutter release button while pressing in the forced film advance
button to wind up the film.
This camera is equipped with a TTL phase difference detection
type auto focus function. When the brightness or contrast is
low and it is difficult to focus, a supplemental infrared light is
emitted automatically. Set the focus mode selector lever to "S"
(single focus mode) or "C" (continuous focus mode).
29
30