Filter
Top Products
Changing the Viewfinder Display in the Manual Mode"M"
(select 'Fd")
When the exposure mode setting dial is set to "M", it is possible to display only the
focus marks and flash charge mark in the viewfinder's LCD panel. This is useful when
exposure settings will not change, and this information in the viewfinder could be
otherwise distracting.
1. Set the shutter release mode selector lever to
"S" (to turn the power on).
2. Press the “F1”
Key for about 2 seconds to
display "Func" on the external liquid crystal
display panel.
3. Turn the front or rear dial to select "Fd".
4. Press the “F1” Key again to display
"OF" or "On" (flashing).
Turn the front or rear dial to select "OF'.
Returning to the normal display
*Repeat steps 1 to 4 about, turn the front or rear dial to select "On", then press
the “SET” Button for 2 seconds.
Error Messages
This is displayed for 3 seconds when the end of the film is
reached while shooting in the "C" (continuous advance) shutter
release mode.
This is displayed when the shutter release button is pressed while
the mirror is up when the exposure mode is set to "P" (program
AE), "Av" (aperture priority AE) or "Tv" (shutter priority AE).
This is displayed when auto bracketing does not function, as follows:
• When the shutter release button is pressed while the exposure mode
is set to "M", "X" or "T", this is displayed, the shutter is not released
and the auto bracketing mode is canceled.
• When the shutter release button is pressed while shooting with the
exposure mode set to "Av", "Tv" or "P" and there are fewer than three
frames of film left, this is displayed, the shutter is not released and the
auto bracketing mode is canceled.
If the magazine is removed while the multiple exposure mode is
set, this is displayed and the multiple exposure mode is
canceled after the magazine is replaced on the camera.
This is displayed when the batteries are discharged and the
camera cannot operate. Please replace batteries with a fresh set.
These are displayed when a problem is detected during
shooting.
If the error display is not canceled when the shutter release
button is pressed again, insert the Dark slide, half-press the
shutter release button while pressing the roll film holder's
manual film advance button to wind up the film, then contact
your nearest Mamiya agent or service center.
77
78