Filter
Top Products
Loading Film
1
Open the back cover and pull
out the spool change knob (22), then
insert an empty spool into the take-
up spool chamber (38) so that it
engages the winding axis. Release
the spool change knob.
Pull out the spool change knob (29),
and insert a roll of film in the film
chamber (40).
PRECAUTIONS
2
Pull
out the leader paper of the
By turning the spool change knobs
film and guide it into the slit of the
(22) and (29) either to the right or
take-up spool, turn the film wind
left after pulling them outward, the
crank (6) clockwise until the start
knobs stay at their protruded posi-
mark on the leader paper matches
tions. Turn the knobs backward to
the start marks (39) on the camera.
reinsert them.
If both spool change knobs are not
returned to their original positions
after loading a film, unbalanced film
winding will result.
Should the spool change knob not
return to its original position, move
the spool slightly to the front and
rear or up and down.
9