Filter
Top Products
Attaching the Roll Film Holder
Removing the Roll Film Holder
*
Remove the Roll Film Holder
Cover.
1. While spanning the Roll Film Holder
between your thumb and middle fin-
ger, holding it on the rubberized fin-
ger rests, carefully align its Film
Holder Mounting Bracket with the
corresponding center clip of the
camera body.
2. While keeping this alignment, press
the upper part of the Roll Film Holder
against the camera body, so that it
clicks into place by engaging the
spring loaded twin camera catch.
1. Insert the Dark slide
into
the slot
marked by White Lines on the side
of the holder.
2. Push the lower one of the Film
Holder Detaching Lock Release
Button (A) downward, while simulta-
neously pushing the Film Holder
Detaching Button
@I
inward.
*
If the
Dark
Slide is not inserted,
the safety lock will prevent the
holder from being removed.
*
The Dark Slide can be inserted
in the Roll Film Holder up to the
Green Line, marked on the slide,
without affecting the image.
Green Line
11