Filter
Top Products
1. While pushing the Back Cover
Lock Release Button (A) downward,
press the Back Cover Opening
But-
ton, and the Back Cover will open.
When you load film
for
the first time,
remove
and discard the protective
paper cover which is attached to the
in the
roll
film holder.
2. While squeezing in on both sides
of the Release Latch
(A)
pull the Roll
Film Insert out of the camera body.
At that time,
move
the empty spool
in the upper part down to the lower
spood
compartment.
18
3.
Align
the right-hand side of this
empty spool with the lower Spool
Stud (A) (convex). Slide the spool
into position making sure that the
left-side of the spool is properly held
by the Spool Clip.